Sony SMAD-P3D 2 channel MI Shoe adapter

SMAD-P3D Multi Interface Shoe (MI Shoe) adaptor for URX-P03D (Dual Channel)

Dual channel Multi Interface Shoe (MI Shoe) adaptor for cable-free connection

The 2-channel wireless receiver URX-P03D can be attached to camcorders or interchangeable-lens cameras that have an MI (Multi-Interface) shoe using the 2-channel MI shoe adaptor SMAD-P3D. This eliminates the need for connecting cables. By using the MI shoe adaptor, audio signals can be transmitted from the wireless receiver to a camera. In addition, the wireless receiver can get power from the camera, and the camera can control power ON/OFF, unifying power management.

The SMAD-P3D is applicable to XDCAM Camcorder PXW-Z280/Z190, PXW-X180/X160, PXW-X280/X200*, PXW-Z150**,***, PXW-FS7, PXW-FS7II, PXW-FS5***, PXW-FS5II***, PXW-Z90 and PXW-X70, NXCAM Camcorder HXR-NX5R**,***, HXR-NX100***, HXR-NX80 and HXR-MC2500, Handycam**** FDR-AX700, FDR-AX100***, FDR-AX60, NEX-VG900 and NEX-VG30, interchangeable lens digital camera**** α7, α7II, α7III, α7R, α7RII, α7RIII, α7RIV, α7S, α7SII, α9, α99, α99II, α6000, α6300, α6400, α6500 and α6600, plus Cyber-shot**** DSC-RX10, DSC-RX10II, DSC-RX10III and DSC-RX10IV (as of October 2019).

* PXW-X200 firmware should be upgraded to Ver.2.00 or later for using SMAD-P3D.
** When using with PXW-Z150 or HXR-NX5R operated by AC power, please set a battery on the camera. Without a battery, we do not guarantee the power supply function or power ON/OFF control function. In that case, insert new AA alkaline batteries in the receiver and set the receiver’s power select (PWR SOURCE) menu item to BATT ONLY mode to avoid an unexpected shutdown of the camera or data loss.
*** When using with these specific camera models recording audio signals from both audio input and multi-interface shoe (MI SHOE), following audio input settings are recommended.
-INPUT1 for CH1 / MI SHOE for CH2 (Audio signal assigned to URX-P03D’s OUTPUT2 will be recorded on CH2)
-MI SHOE for CH1 / INPUT2 for CH2 (Audio signal assigned to URX-P03D’s OUTPUT1 will be recorded on CH1)
Please beware of the audio signal assignment in following setting.
-MI SHOE for CH1 / INPUT1 for CH2 (Audio signal assigned to URX-P03D’s OUTPUT2 will be recorded on CH1)
**** When using with these specific camera models (all Handycam, interchangeable lens digital camera and Cyber-shot), we do not guarantee the power supply function or power ON/OFF control function. Insert new AA alkaline batteries in the receiver and set the receiver’s power select (PWR SOURCE) menu item to BATT ONLY mode to avoid unexpected shutdown of the camera or data loss.

No need for separate XLR cable
Using an MI Shoe connection, the 2-channel audio signal from wireless receiver URX-P03D can be input to the camera without XLR cables.

Power can be supplied by camera
Power can be switched on and off from the camera/camcorder.