CyanView CY-CBL-TILTA-USB, Adapterkabel for Tilta Nucleus-M fra CI0/RIO USB-Port 50cm

Denne kabelen gir kontroll over Tilta motor og fjernkontroll. Fjernkontrollen vil strømforsynes med denne kabelen, mens motorene må strømforsynes separet ved hjelp av Tilta D-tap kabel på den andre kontakten på motoren.

kabel er 50cm lang og har en USB-A i ene enden og en Lemo 6-pinnes kontakt i andre enden.(FGG.0B.307.CLAD52Z)

A Nucleus-M Wireless Lens Control System can be controlled by a Cyanview system.

Wiring​

You just need to connect the Nucleus-M to the RIO port using the cable CY-CBL-TILTA-SERIAL. Ensure all your motors have differents ID's and then you can daisy chain them.

For one motor on a small lens, the RIO port power supply is usually enough. But we recommend using external power supply (D-TAP, etc. ) that you can connect directly in the cable CY-CBL-TILTA-SERIAL. This way, the power supply is external and the RIO is just used for the control.

In case both ports of the RIO are used (a serial camera and a serial robotic head), then we have an alternative cable: CY-CBL-TILTA-01 that plugs in the RIO USB port. With this cable, external power supply is mandatory.

Sometimes the CY-CBL-TILTA-01 is labeled CY-CBL-TILTA-USB